Titanium Hydride
MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Manufacturer/Supplier:
ESPI Metals
1050 Benson Way, Ashland, OR 97520
Toll Free (800) 638-2581 * Fax (541) 488-8313
E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Product Name: Titanium Hydride
Formula: TiH2
CAS Number: 7704-98-5
II. HAZARDOUS INGREDIENTS
Hazardous Component: Titanium Hydride
Percent (%): 0-100
OSHA/PEL: 10 mg/m3
ACGIH/TLV: 10 mg/m3
HMIS Ratings:
Health: 2
Flammability: 3
Reactivity: 2
III. PHYSICAL DATA
Boiling Point: N/A
Melting Point: 400 oC (decomposes)
Specific Gravity: 3.9 g/cc @ 12
Solubility in H2O: Soluble
Appearance and Odor: Grey-black metallic powder, no odor
IV. FIRE AND EXPLOSION HAZARDS DATA
Flash Point: N/A
Autoignition Temperature: 460 oC
Explosive Limits: Lower: N/A Upper: N/A
Extinguishing Media: DO NOT USE WATER. Use class D or other metal extinguishing agent.
Special Firefighting Procedures: Firefighters must wear full face, self-contained breathing apparatus with full protective clothing to prevent contact with skin and eyes. Fumes from fire are hazardous. Isolate runoff to prevent environmental pollution.
Unusual Fire and Explosion Hazard: When heated to decomposition, titanium hydride may emit flammable hydrogen gas. May have a violent reaction with oxidizing agents. Titanium hydride dissociates above 288 oC and gradually evolves hydrogen gas. Dust-air mixtures may be explosive. Contact with water releases explosive hydrogen gas.
V. HEALTH HAZARD INFORMATION
Effects of Exposure:
To the best of our knowledge the chemical, physical and toxicological properties of titanium hydride have not been thoroughly investigated and recorded.
Titanium compounds: There are no reported cases in the literature where titanium as such has caused human intoxication. The dusts of titanium or most titanium compounds may be placed in the nuisance category. (Sax, Dangerous Properties of Industrial Materials)
Acute Effects:
Inhalation: Dust may cause irritation to the upper respiratory system.
Ingestion: Ingestion of titanium hydride is considered non-toxic.
Skin: Prolonged or repeated contact may cause irritation.
Eye: Prolonged or repeated contact may cause irritation.
Chronic Effects:
Inhalation: May cause slight lesions in the lungs. No other chronic health effects recorded.
Target Organs: No target organ effects recorded.
Medical Conditions Generally Aggravated by Exposure: Pre-existing lung disorders.
Carcinogenicity: NTP: No IARC: No OSHA: No
EMERGENCY AND FIRST AID PROCEDURES:
INHALATION: Remove victim to fresh air, keep warm and quiet, give oxygen if breathing is difficult and seek immediate medical attention.
INGESTION: Give 1-2 glasses of milk or water and induce vomiting, seek immediate medical attention. Never induce vomiting or give anything by mouth to an unconscious person.
SKIN: Remove any contaminated clothing, brush material off of skin, wash with mild soap and water, seek immediate medical attention.
EYES: Flush eyes with lukewarm water, lifting upper and lower eyelids, for at least 15 minutes. Seek immediate medical attention.
VI. REACTIVITY DATA
Stability: Stable
Conditions to Avoid: None
Incompatibility (Materials to Avoid): Oxidizing agents, acids, halogens, halocarbons, water/moisture.
Hazardous Decomposition Products: Hydrogen gas
Hazardous Polymerization: Will not occur
VII. SPILL OR LEAK PROCEDURES
Steps to Be Taken in Case Material Is Released or Spilled: Wear appropriate respiratory and protective equipment specified in section VIII. Isolate spill area, provide ventilation and extinguish sources of ignition. Vacuum up spill using a high efficiency particulate absolute (HEPA) air filter and place in a closed container for proper disposal. Take care not to raise dust. Use non-sparking tools.
Waste Disposal Method: In accordance with Local, State and Federal Waste Disposal Regulations.
VIII. SPECIAL PROTECTION INFORMATION
Respiratory Protection: NIOSH-approved dust, mist, fume respirator.
Ventilation: Handle under dry argon. Use local exhaust to maintain concentration at or below the PEL, TLV. General exhaust is recommended.
Protective Gloves: Rubber gloves
Eye Protection: Safety glasses
Other Protective Clothing or Equipment: Protective gear suitable to prevent contamination.
IX. SPECIAL PRECAUTIONS
Precautions to Be Taken in Handling and Storage: Wash thoroughly after handling. Do not get in eyes, or on skin or clothing. Do not breath dust, vapor, mist, or gas. Keep container closed. Keep away from heat, sparks and open flame. Store in a tightly closed container. Do not store near combustibles. Empty container may contain hazardous residues. Flammable solid. Keep material cool. Handle under argon if possible as material can heat up and ignite during manipulation.
Other Precautions: Store away from water/moisture. Do not store together with acids. Store away from halogens. Store away from oxidizing agents. Protect against electrostatic charges.
Work Practices: Implement engineering and work practice controls to reduce and maintain concentration of exposure at low levels. Use good housekeeping and sanitation practices. Do not use tobacco or food in work area. Wash thoroughly before eating and smoking. Do not blow dust off clothing or skin with compressed air. Maintain eyewash capable of sustained flushing, safety drench shower and facilities for washing.
The above information is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide. ESPI shall not be held liable for any damage resulting from handling or from contact with the above product.
Prepared by: S. Dierks
Dated: April 2005